Introduction

With Evocon device 3.0, you can configure its WiFi and network settings just like you would on a router. If the Evocon device fails to find a suitable WiFi network, it creates its personal WiFi network, from which you can manage the device’s network settings.

1. Preparation

Prepare the information required to access the device

1. Open https://app.evocon.com/#/settings/devices

2. Find the device using the serial number (on the left side of the device)

3. Open the device information card in the Evocon app

   

4. Copy or note the WiFi MAC address

5. Copy or note the Command line password

2. Connecting to the device

1. When restarted, the Evocon device tries to connect to known WiFi networks. Once it fails to do so within ~1 minute, it creates a WiFi network with the name Evocon_<device’s MAC address>.

You must connect to this Evocon_<device’s MAC address> WiFi network to set up a different WiFi network.

The password of the device’s WiFi network is evoconsetup.

1. Once connected to the WiFi network, navigate to address 192.168.4.1 with your favourite web browser.

2. A login window will appear in the browser’s alert window.

   1. Insert username. ← The username is the device’s WiFi MAC address you copied earlier.
   2. Insert password. ← The password is the device’s CLI (command line interface) password you copied earlier.

3. Setting up WiFi

1. When you are on the device configuration form, enter your WiFi credentials and/or other static IP configurations into the form and click on the Save button.

   

   The opened page will look similar to this

2. After pressing the “Save and restart device”, a confirmation alert window will appear and the device will start a restart. Upon booting up, it will connect to the WiFi network you configured.