1. Check the status of the Evocon device by looking at the green and yellow lights next to Ethernet (network cable) connector. You can also see the status of the device from the systems’ point of view at https://app.evocon.com/#/settings/devices

   • If the green light is on or blinking, the device has power.
   • If the yellow light is blinking, the device has power and physical connection to the next networking device.
   • If no lights are blinking, make sure the power adapter is plugged in and there is 24V DC voltage on the connector that connects to the device.
   • If only the green light is on or blinking, but network cable is connected, then check the network cable or the next networking device.

2. If the Evocon device is powered on and the network cable is connected, but the problem persists, then contact your local IT personnel. Provide them with the MAC address (can be found at https://app.evocon.com/#/settings/devices ) and ask them to check if that device is:

   • Registered on the network and has an IP-address from the DHCP server.
   • Active on the network (sending packets/receiving packets).
   • Not blocked by configuration, firewall or access control filter.

3. Make sure that the firewall settings allow traffic from the device towards the Internet.

   Hardware - Evocon IIoT device 3 - Network configuration

4. If the data logger is powered on and no changes or errors are detected on the network, contact [email protected]. Make sure to provide the following information:

   • Serial number or MAC address of the device or station/line name connected.
   • Which actions have been taken so far and what were the results.

You can find more detailed information from our webpage: How to set up an internet connection for Evocon?